Hand Casting Kit Couples - Hand Mold Kit Couples, Wedding Engagement Gifts for Couples Husband Wife, Girlfriend Boyfriend

FQA

For step 1 - Pour the Algiante Molding Powder into the bucket and it turns blue before you stir it in. Why?

• Answer: There are roughly 4 situations when it turns blue immediately: 1. The amount of water added is seriously insufficient. 2. The water is hard. 3. The water temperature is higher than 30 degrees. 4. The powder has been left for too long.
• The solution is to use 2000ML pure water around 28 degrees.

For step 1 - The manual said to put your hand into the purple molding liquid and wait for 3-10 minutes for it to solidify, but I waited for 30 minutes. Why?

• Answer: Probably the pure water used by the customer is very cold water, and it will solidify in 30 minutes. The solution is to use 2000ML pure water around 28 degrees.

For Step 2 - The casting powder will harden as soon as you add water. How much water should be added specifically? How many minutes to wait to pour into the mold?

• Answer: basically need to add 420ml water ; Stir continuously for 1 minute until it becomes viscous.
• Scenarios for hardening after adding water: 1. If the water volume is less than 400ml, it will solidify completely within 60 seconds. 2. The water quality is very hard or alkaline, which will accelerate solidification. 3. The powder packaging is damaged and is left damp and is not used immediately after opening the packaging.
• If there are many such problems, the amount of water can be increased to 450 ml.

Why are there bubbles after molding?

• Answer: This situation is normal. During the first step of production, bubbles will be generated during stirring, causing the model in the second step to have small particles. These particles are generally very weak and can be disappeared by sandpaper or rubbing with your hands.

Why mold fingers are missing.

• Answer: This situation is called air U-shaped obstruction. During the mold filling process, the gypsum solution did not completely enter the U-shaped edge of the mold with bubbles. The solution is: pour it along the mold wall when pouring the mold, and tap it during the mold filling process. When half of the filling is done, tap and shake vigorously until the bubbles are completely discharged, and you will get a complete model.