Livelynine White Peel and Stick Wallpaper Wood Contact Paper for Cabinets Adhesive Wood Grain Vinyl Wrap for Kitchen Furniture Textured Thick Wood Countertop Waterproof Wall Paper Bathroom 15.8x78.8

Step 1. Prepare the surface and tools

Make sure the surface to be covered is

cleaned, dry, and free from grease.

If the surface is rough or uneven, rub

it over with sandpaper to smooth and

level it

Step 2. Measure surface and cut wallpaper

Measure the length and width of the surface

to be covered, If the surface shape is complex

one, sketch a rough outline of it in a notebook

and write measurements for each part of the

outline on your sketch.

Step 3. Apply peel and stick

Smooth the wallpaper flat and make sure it will fit the surface properly,

free one corner of the backing paper,then pull more backing paper free

until expose around 1/4 inch of backing.Press the 1/4-inch wallpaper

against the surface you wish to cover. Work slowly from one corner of

the strip to the other.

Step 4. Smoothing the wallpaper to avoid wrinkles and air bubbles. Trim off excess

Gently pull the rest of the 1/4-inch paper.Take your time to get this right.

Working from side-to-side to keep the paper smooth,flatten out wrinkles

and expel any air that might get trapped and form a bubble. If wrinkles

and bubbles do occur,gently tear the wallpaper free and try again.

Continue drawing off the backing and smoothing until the whole surface has been covered. Trim off any excess wallpaper

How to instal ?

Installation guide come packed with wallpaper roll. Kindly unpack it carefully.

No wide enough ?

It is 15.8 inch wide. If the surface going to be covered is wider. please kindly overlap the edge of wallpaper to cover whole item, the seam is invisible. or below have wider width contact paper for choose.

Lot of wrinkles and bubbles ?

Incorrected installation would form bubbles or wrinkles, please take your time to install, If wrinkles and bubbles do occur, gently tear the wallpaper to try again, really can't avoid it, please use a small pin to poke the bubble and smooth down from edge toward hole.

Can stick on textured wall ?

Textured walls' dips, holes, and gaps reduce the surface area that can contact the wallpaper. The wallpapers will fall down easier than on flat walls, please read below tips before stick-on textured wall: 1. Sand your walls into smooth & dust-free before stick on wallpaper. Or 2. Spray 3M adhesive(or liquid paste) to fill in the gaps & other low spots on wall to make sure sticky wallpaper good attached to your walls.