Painted stainless steel bike trailer hitch for Burley trailers, durable and solid. Works with disc brake and full suspension bikes
Fits QR axles and solid axles up to 12mm (OD=0.48in).
12mm Thru-Axles will require Burley’s adapted Thru-Axle. This replacement axle has external threading to accommodate the installation of our axle mounted hitches.
If you are upgrading from a Classic Hitch to this Steel Hitch, you will also need a Flex Connector. (Flex Connector not included, but you can find it in our store.)
Warning: Can not fit with Breezer style dropouts.
Our trailer hitch are made of strong stainless steel and well finished No burr ! Products from other 's may looked like ours in picture, but they actually not! Product it self don't tell lie.
Product Specifications
Item Weight: 4.7 ounces
Package Dimensions: 3.66 x 2.44 x 1.54 inches
Is Discontinued By Manufacturer: No
Manufacturer Part Number: OD-C01
Product Information
Product description
ODIER Bike Trailer Hitch
How to Install the Hitch
1. Open the quick release lever, and remove the nut and spring from the opposite side. Hold the lever and pull the axle skewer with spring out. Completely remover the skewer but leave the wheel in place.
2. Slide the hitch onto the skewer. (The wide end of the spring should face out and touch the lever, the bell of the hitch should face out.)
3. Insert the end of the skewer through the wheel hub and. Replace the spring (wide end out!) over the end of the skewer,followed by the nut.
4. Adjust the hitch to a right angle and tighten the nut by hand and clamp the lever. Connect the trailer with the coupler by a D pin.
About the hitch
Painted stainless steel bike trailer hitch for Burley trailers, solid and strong. Works with disc brake and full suspension bikes
Fits QR axles and solid axles up to 12mm (OD=0.48in).
12mm Thru-Axles will require Burley’s adapted Thru-Axle. This replacement axle has external threading to accommodate the installation of our axle mounted hitches.
If you are upgrading from a Classic Hitch to this Steel Hitch, you will also need a Flex Connector. (Flex Connector not included, but you can find it in our store.)
Warning: Can not fit with Breezer style dropouts.
Our trailer hitch are made of stainless steel and well finished. Product it self don't tell lie, try ours and you'll find it just as good as the original.
Related Accessories
Safety Strap
If the original obvious aging or torn. You may need this replacement part.
Felx Connector for Round Tow Arm
You can convert your classic hitch into this angled steel hitch.
If your original flex connector is becomin hard and been used for over 2 years, you may need replace with this one.
(Other bicycle trailer may match this connector if the tow arm tube size is between 21.5mm to 23.5mm.)
Felx Connector for Square Tow Arm
You can convert your classic hitch into this angled steel hitch.
If your original flex connector is becomin hard and been used for over 2 years, you may need replace with this one.
(Other bicycle trailer may match this connector if the tow arm tube size is between 21.5mm to 23.5mm.)
Make sure all part connected right before towing
Please make sure all accessories are connected correctly before use.