Funshow Case UV Resin Silicone Mold Geometry Pendant Jewelry Epoxy Resin Plaster Clay Handmade Hole Hole 10 Cavities

Note: all measurements are approximate due to handmade nature and may change when sanded

Finish: gloss ( may require polish or glaze if need a shiniest or most glossy look )

Transparent silicone, so you may check the bottom during project

Food grade. Food and not food material should use separately

Wash and boil before use, especially for food to sterilize

Flexible, easy to clean, used in oven, dishwasher, refrigerator.

Suffer temperature -40~220 centigrade (-40~428 fahrenheit)

More Tips to use with Epoxy Resin:

1) poured in silicone molds in layers, allowing air bubbles completely escape;

2) to expedite the process of escaping of bubbles and time of solidification of resin, the mold can be a bit warmed up, for example, heat the oven to 80°C, turn off, ventilate it a little and put mold, filled with resin in the oven.

3) follow resin instruction for the time need to cure, measure and mix resin properly. It does not mean it has been cured if it is hard.

4) do not use water-base ink for resin casting.

5) After baking clay / resin in complex or deep molds remove the finished product under running water with soap.

6) Put in refrigerator a while/ soak in hot water a while/ release with baby oil if it is hard to release.

Frequently Asked Question: What to do with the mold stuck to the projects?

Resin stuck would be for varied reasons.

1. You may make the proportion of 2-part resin and wait until dry under the brand recommends.

2. Please mix less than 100g at a time and repeat it.

3. You may add baby oil or place the mold under running water with soap.

4. Try to add less water-based ink with the resin, the more ink should be the more sticky.

5. Please mix the resin well and always in the SAME direction.

6. You may place it in the refrigerator or hot water for a while before de-molding.