LET'S RESIN UV Resin with Light,Upgraded 200g Crystal Clear&Low Odor,UV Light,Silicone Mat,Ultraviolet Epoxy Resin Hard, Starter Kit for Jewelry,Craft Decor

Advantages of LET'S RESIN UV Resin

• Low Viscosity: UV resin has high adhesion, the viscosity is as high as 2000cps, and it can bond various materials, such as glass decoration, crystal craft, crystal characters, etc.
• Good Curing: Well-tailored UV adhesive formula and perfect photoinitiator ratio help you achieve the best curing effect during production.
• High Gloss: UV resin kit is added with antioxidants, and the refractive index material is more than 1.5 times higher, making the finished work more transparent and resistant to yellowing than other UV glues.
• Low Odor: Reactive diluent is added to reduce VOC volatile components, minimize odor, and allow you to use with more confidence.

UV Resin Curing Time

UV Resin Creative Works

• Perfect for making vaulted, sealed and tiny delicate landscape DIY works like ocean waves, water splashes, wine cooler micro-scapes, paintings, decorative lights and more.

Customer DIY Works

Some Q&A of your concern：

Q1: Why does it not cure even after putting it under UV light for hours?Why is it sticky/tacky?

A: Please check if you are in one of the following situations.

• Wrong molds

Since UV resin is not casting resin, any mold that is large, deep or opaque is not for UV resin. If you want to make coasters, trays, or any other objects larger than 8cm, UV resin is not what you are looking for. Epoxy resin will definitely do a better job.

• Wrong pigments

Not all pigments work with UV resin. You will need to use pigments that’s specially for UV resin. Alcohol inks, opaque pigments are NOT recommended. Specially notes for using black pigments: Black color, in any sort of pigment, is tricky to work with UV resin. Please mix a tiny amount of black pigment and cure it in layers. Or pour a clear layer of UV resin and cure it first, then add black UV resin on top.

• Not enough UV light exposure

Please make sure you are using the correct UV light/lamp. If you are using a silicone mold, please make sure both the upper side and bottom side get enough UV light. That is to say,cure the back side under the UV light for the same time.

• Adding too much

If you add too much pigments, glitters, mica powder or other fillings, it won’t let enough UV light go through the UV resin to cure it properly.If it is sticky/tacky on the surface, you can simply coat a layer of clear UV resin. Let it cure under the UV light for 3-5 minutes.

Q2: How to remove the bubbles?

A: The more thicker the UV resin is, the more bubbles you will get when squeeze it out from the nozzle. And the viscosity of the UV resin will increase if the temperature is low. So heat up the UV resin is an effective way to reduce bubbles. Here are some tips may help:

• Pop the bubbles with a toothpick or a silicone stick.
• Heat up the UV resin with a heat gun or using a heating plate.