HeatnBond Hem Iron-On Adhesive, Super Weight, 3/4 Inch x 8 Yards, White

General Directions

Pre-wash all materials without fabric softeners. Pre-test adhesive on materials before starting project.

1. Preheat iron to medium heat, no steam.
2. Turn item inside-out or turn over.
3. Measure & press new hem into the fabric.
4. Place Tape inside the new folded hem.
5. Place iron on fabric and hold with firm pressure for 8 seconds on each section, slightly overlapping, until the entire surface is bonded.
6. Turn item right side out and iron fabric for additional 3 seconds on each section, slightly overlapping, until the entire surface is bonded.

Tips:

• Pre-wash all materials (without fabric softener) you will be using prior to fusing
• Do not touch iron directly to the Hem Tape. Do not iron directly to your ironing board. There is not a protective paper backing and the adhesive will melt to your iron or your ironing board. You must sandwich this adhesive between the two layers of fabric to be fused before applying your iron
• Machine wash delicate cycle warm, tumble dry low heat or no heat (and in accordance to garment / fabric washing directions). Avoid repeated or excessive ironing to the area after fusing. DO NOT DRY CLEAN