LONYE Rubber Bushing Shock Pad Fit for 250W Magic Bullet MB1001 Blender Juicer Mixer(Pack of 6)

Step 1: prepare tools

prepare a dish tower/rag/paper tower, basic flat pliers, and flat-head screwdriver(flat & narrow)

Step 2:

• hold the blades using the towel, take the gear on the back end,
• take the pliers to grip down on the gear using even solid pressure,
• turn the gear clockwise, it will loosen up, and see the little screws.

Step 3:

Grab the towel to hold the blades again, screw the good gear in going counterclockwise, take the pliers to make the gear clamp down tightly

Step 4:

Take out of the base and plastic part using the flat-head screwdriver through the little notch on the bottom

Step 5:

Put the screwdriver into the notch, grab the pliers slide the base in, take the base clockwise out and you will see the thread right. Notice: When you move the screwdriver, the gear will move meanwhile.

Step 6: Change the good base

grab the pliers on one side, tighten the base counterclockwise using the pliers to bite down.

Step 7:

when the blade gear & rubber gear is installed well,the blender will be in good condition.

Step 8:

install the shock pad according the picture shown.