Smooth-On Universal Mold Release - 14 Fluid Ounce Aerosol Can

Universal Mold Release Agent is formulated especially for mold making and casting, and works well with most liquid rubber and liquid plastic products. It will release mold rubbers (such as polyurethanes and polysulfides) from properly prepared models. Sealing porous models (wood, plaster, concrete) or certain modeling clays (containing water or sulfur) with Smooth-On SuperSeal or other sealer (such as spray shellac) may be necessary. Universal Mold Release is effective over a broad temperature range from 70°F to 500°F.

If using silicone rubber, seal model surface with SuperSea only. Do not use Universal Mold Release. Universal Mold Release also easily releases a variety of casting materials (epoxies, Smooth-On liquid plastics, etc.) from cured rubber molds. This product has a limited shelf life and should be used as soon as possible. Properly used, Universal Mold Release improves molding efficiency for a variety of casting applications and will actually lengthen the life of your production mold.

CONTENTS FLAMMABLE: Keep product away from flame and all ignition sources. Use this product in a properly ventilated area with at least room size ventilation. Wear safety glasses, long sleeves and rubber gloves to minimize contamination risk. Store and use material at room temperature (73°F/23°C). Apply a Sealing Agent if Necessary - Porous surfaces (concrete, plaster, etc.) often require a sealing agent followed by a release agent when releasing liquid mold making materials. Follow directions on the mold material technical bulletin before proceeding.

Because no two applications are quite the same, a small test application to determine suitability for your project is recommended if performance of this material is in question. Refer to technical bulletin for more information available at Smooth-on website.

Adult Supervision Required. Keep Out of the Reach of Children.