1. Why won’t my machine pick up the bobbin thread?

Ensure the bobbin-winding spindle has been pushed to the correct position. Otherwise, the needle will not go down and pick up your bobbin thread. Next, ensure the bobbin thread is hooked up from the hole of the needle plate and the length is about 15cm.

2. Be careful when changing the needle.

Before changing the needle, turn off the switch and cut off the power supply. The needle installation direction must be correct, and the thimble screw must be tightened to avoid needles falling off!

3. When using foot pedals.

After using, please pull out the foot and power plug to avoid accidentally touching!

4. Before sewing, please check whether the threading sequence is correct.

Wrong threading steps will cause the machine to fail to start. Before adjusting the stitch wheel, please turn off the switch first, and turn the hand wheel to raise the needle to the highest position. Otherwise, it will cause needle bending! The upper thread is pressed under the presser foot, pulls out the fabric to the left, and cannot be pulled forward. Otherwise, it will cause the needle to bend.

5. Notes on a double needle and reverse stitching.

Double-needle sewing and reverse stitching are only for straight sewing stitches!